[Moabusers] large number of jobs queued

[Justin Bronder]

On 9/25/06, Thomas G. Raisor <thunder at et.byu.edu> wrote:
>
> Hi,
>
> I have about 25,000 jobs in my torque queue right now, but moab is only
> seeing roughly the first 4100 (using showq).  Jobs not shown with showq
> give the following error when I do a checkjob on them.
>
> ERROR:  cannot locate job 'jobid'
>
> I can run the jobs with qrun with no problems. This is a vanilla install
> of moab - are there defaults parameters I need to increase? I was using
> an older patch release of moab 4.5, updated to the latest and get the
> same behavior. Could it be torque not communicating its jobs to moab?
> torque version is 2.1.0 - (yes, I know I am a little out of date, but I
> haven't had any problems until now.)
>
> Suggestions?
>
> Tom
>
> _______________________________________________
> moabusers mailing list
> moabusers at supercluster.org
> http://www.supercluster.org/mailman/listinfo/moabusers
>



It should be seeing the first 4096 jobs actually.  Anyways, you can adjust
the
default limits, which is something I had to do for partitions.  Refer to the
following page and the MAXJOB variable.

http://www.clusterresources.com/products/mwm/docs/a.ddevelopment.shtml

-Justin.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.supercluster.org/pipermail/moabusers/attachments/20060926/a21a7d7f/attachment.html