[Moabusers] large number of jobs queued

[Thomas G. Raisor]

Hi,

I have about 25,000 jobs in my torque queue right now, but moab is only
seeing roughly the first 4100 (using showq).  Jobs not shown with showq
give the following error when I do a checkjob on them.

ERROR:  cannot locate job 'jobid'

I can run the jobs with qrun with no problems. This is a vanilla install
of moab - are there defaults parameters I need to increase? I was using
an older patch release of moab 4.5, updated to the latest and get the
same behavior. Could it be torque not communicating its jobs to moab?
torque version is 2.1.0 - (yes, I know I am a little out of date, but I
haven't had any problems until now.)

Suggestions?

Tom